Confirming that Network Scan is Enabled

1. On a computer connected to the same network as the printer, open a browser and enter the printer's IP address.

   You can check the printer's IP address using the following menu.

   • Network connected to the printer's built-in LAN port
     Settings > General Settings > Network Settings ( > Standard) > Network Status > Wired LAN/Wi-Fi Status
   • Network connected to the Wireless LAN Interface-P1
     Settings > General Settings > Network Settings >Network Status > Wired LAN/Wi-Fi Status

2. Enter the administrator password to log in as an administrator.

3. Select these menu items in the following order.

   Scan/Copy tab > Network Scan

4. Make sure that Enable scanning of Epson Scan 2 is selected.

   If it was already selected, this task is completed. Close Web Config.

   If it was not already selected, select it and go to next step.

5. Click Next.

6. Click OK.

   The network scanning service is re-enabled.