You can set the network scan service when you scan from a client computer over the network. The default setting is enabled.
Enter the printer's IP address into a browser to access Web Config.
Enter the printer's IP address from a computer that is connected to the same network as the printer.
You can check the IP address of the printer from the following menu.
Settings > General Settings > Network Settings > (Standard) > Network Status > Wired LAN/Wi-Fi Status
Enter the administrator password to log in as an administrator.
Select in the following order.
Scan/Copy tab > Network Scan
Make sure that Enable scanning of Epson Scan 2 is selected.
If it is selected, this task is completed. Close Web Config.
If it is cleared, select it and go to next step.
Click Next.
Click OK.
The network is re-connected, and then the settings are enabled.