AM-C6000 Series/AM-C5000 Series/AM-C4000 Series

User's Guide

> Preparing the Printer and Making Initial Settings > Settings for Printing, Scanning, Copying and Faxing > Preparing Scanning or Copying > Preparing to Scan > Using Document Capture Pro Server > Setting Server Mode

Setting Server Mode

To use Document Capture Pro Server, set up Server Mode from Web Config.

Note:

You can also set Server Mode from the control panel by accessing the following menu.

Settings > General Settings > Scan Settings > Document Capture Pro > Operation Mode

  1. Enter the printer's IP address into a browser to access Web Config.

    Enter the printer's IP address from a computer that is connected to the same network as the printer.

    You can check the IP address of the printer from the following menu.

    Settings > General Settings > Network Settings > (Standard) > Network Status > Wired LAN/Wi-Fi Status

  2. Enter the administrator password to log in as an administrator.

  3. Select in the following order.

    Scan/Copy tab > Document Capture Pro

  4. Select Server Mode for Mode.

  5. Enter the address of the server with Document Capture Pro Server installed on it for Server Address.

    Enter between 2 and 255 characters in either IPv4, IPv6, host name or FQDN format. For FQDN format, you can use alphanumeric characters in ASCII (0x20-0x7E) and "- " except for at the beginning and end of the address.

  6. Click OK.

    The network is re-connected, and then the settings are enabled.