When scanning using the ADF and the following conditions occur, the scanner detects an excessive load on the ADF and immediately stops scanning to reduce damage to the original.
A paper feed error has occurred
An original is fed at an angle
To enable this feature, select the level of detection you want to use. See the following table for details on each level.
|
Level |
Explanation |
|---|---|
|
On-Low |
Lower the sensitivity to detect the skew of the originals. |
|
On-Medium |
Detect the skew of the stapled originals and the skew that On-Low could not detect. |
|
On-High |
Increase the sensitivity to detect the skew of the originals. |
This feature does not prevent all originals from being damaged.
Paper feed errors may not be detected depending on the condition of the originals being fed.
This feature may not work correctly depending on the original, the paper feeding conditions, and the level set.
If false positives occur frequently, try lowering the level.
If the original is an irregular shape or is scanned at an angle, it may be mistakenly detected as a paper feed error.
When loading multiple originals, make sure to align the leading edge of the originals. Originals may be misdetected as feeding errors if the edges of the originals are not aligned, even if they are scanned correctly.
Make sure you align the edge guides with the original to avoid scanning it at an angle.
When scanning using the ADF, detects dirt on the glass surface inside the scanner (the ADF reading sensor). You can select the level of the detection.
Depending on the dirt, this feature may not work correctly.
Set the timeout when using Add Pages After Scanning.
This setting is only available when scanning from "Network Folder/FTP", "Email", "Cloud", or "USB drive". You can set the time to finish scanning automatically when "Add Pages After Scanning" is set to "On".
You can check destination before scanning.