You can set the firmware to update automatically when the printer is connected to the Internet.
When the panel lock is enabled, only the administrator can execute this function. Contact your printer administrator for assistance.
Select Settings on the printer's control panel.
Select General Settings > System Administration > Firmware Update.
Select Automatic Firmware Update to display the settings screen.
Select Automatic Firmware Update to enable this feature.
Select Agree on the confirmation screen to return to the settings screen.
Set the day and time for the update, and then select OK.
You can select multiple days of the week, but you cannot specify the time for each day of the week.
Setup is complete when the connection to the server is confirmed.
Do not turn off or unplug the printer until the update is complete; otherwise, the printer may malfunction.
If the firmware update is not completed or is unsuccessful, the printer does not start up normally and "Recovery Mode" is displayed on the LCD screen the next time the printer is turned on. In this situation, you need to update the firmware again on your computer by following the steps below.
1. Connect the computer and the printer with a USB cable, paying attention to the points below.
During recovery mode, you cannot update the firmware over a network connection. You can only use a USB connection.
Use a USB 2.0 type A‐B cable. You can also use a USB 3.0 cable for some models.
2. Download the latest firmware from your local Epson website to your computer, and then start updating.
You can set to update the firmware automatically from Web Config. Select the Device Management tab > Automatic Firmware Update, enable the settings, and then set the day of the week and time.