Scanning Different Sizes or Types of Originals One by One Continuously (Automatic Feeding Mode)

1. Start Epson ScanSmart.

2. Click Settings.

3. Click Scan Settings on the Scanner Settings tab.

   

   The Epson Scan 2 window is displayed.

4. Select Automatic Feeding Mode on the Main Settings tab.

   

5. Make other settings for scanning on the Epson Scan 2 window.

   Note:

   You can make timeout settings to finish Automatic Feeding Mode.

   Select Settings on the Document Source list to open the Document Source Settings window. Set Automatic Feeding Mode Timeout (seconds) on the window.

6. Click Save to close the Epson Scan 2 window.

7. Click Close to close the Settings window.

8. Click Scan double-sided or Scan single-sided.

   Automatic Feeding Mode starts.

9. Adjust the edge guides, and then place the original in the ADF.

   Scanning starts automatically.

10. After scanning stops, place the next original in the ADF.

    Repeat this procedure until you have scanned all originals.

    Note:

    • If you want to scan originals that are detected as double feeds, for example plastic cards or envelopes, press the (Double Feed Detection Skip) button before placing the original to skip double feed detection.

    • If you want to scan originals that are likely to jam, for example thin paper, press the (Slow Mode) button before placing the original to slow down the scanning speed.

11. After you have scanned all originals, exit Automatic Feeding Mode.

    Click Finish on the Automatic Feeding Mode window displayed on your computer.