Placing Laminated Cards

1. Make sure that the scanner position icon is (straight path position).

   

   If (vertical path position) is displayed, pull the scanner position selector to tilt the scanner back.

   

2. Open the input tray.

   

3. Raise the input tray extension.

   

4. Move the edge guides to the edges of the input tray.

   

5. Load the plastic cards with the side to be scanned facing up with the top edge facing into the ADF.

   Insert the paper into the ADF until it meets resistance.

   

6. Adjust the edge guides to fit the edges of the cards so that there are no gaps. If there are any gaps, the original may be fed skewed.

   
   Note:

   • If the edge guides are too far apart or too tight, the original may not be fed correctly. The edge guides should be aligned so that they lightly touch the edges of the original.

   • To scan laminated cards, set the appropriate setting in the Epson Scan 2 window.

     When you are using Epson ScanSmart, you can open the Epson Scan 2 screen by clicking the Settings button > Scanner Settings tab > Scan Settings.

     · To increase the accuracy of auto size detection, select the Main Settings tab > Document Size > Settings > Scan laminated card. See the Epson Scan 2 help for details.

     · Select the Main Settings tab > Detect Double Feed > Off. See the Epson Scan 2 help for details.

     If you have not disabled Detect Double Feed on the Epson Scan 2 screen and a double feed error occurs, remove the cards from the ADF and reload them.