Cleaning the Translucent Film

When the printout is not improved after aligning the print head or cleaning the paper path, the translucent film inside the printer may be smeared.

Items required:

  • Cotton swabs (several)

  • Water with a few drops of detergent (2 to 3 drops of detergent in 1/4 cup of tap water)

  • Light for checking smears

Important:

Do not use cleaning liquid other than water with a few drops of detergent.

  1. Turn off the printer by pressing the button.

  2. Close the document cover if it is open.

  3. Open the scanner unit with both hands until it locks.

  4. Check if the translucent film is smeared. Smears are easier to see if you use a light.

    If there are smears (such as finger marks or grease) on the translucent film (A), go to the next step.

    A: Translucent film

    B: Rail

    Important:

    Be careful not to touch the rail (B). Otherwise, you may not be able to print. Do not wipe off the grease on the rail, because this is necessary for operations.

  5. Moisten a cotton swab with the water with a few drops of detergent so that it is not dripping water, and then wipe the smeared part.

    Important:

    Wipe off the smear gently. If you press the cotton swab too hard to the film, the springs of the film may be dislocated and the printer may be damaged.

  6. Use a new dry cotton swab to wipe the film.

    Important:

    Do not leave any fibers on the film.

    Note:

    To prevent the smear from spreading, frequently replace the cotton swab with a new one.

  7. Repeat steps 5 and 6 until the film is not smeared.

  8. Visually check that the film is not smeared.

  9. Close the scanner unit.

    Note:

    The scanner unit is designed to close slowly and resist a little as a precaution against catching fingers. Continue to close even if you feel some resistance.