ET-5170 Series L6490 Series ET-5150 Series L6460 Series

User's Guide

> Solving Problems > Paper Gets Jammed > Removing Jammed Paper

Removing Jammed Paper

Caution:

Never touch the buttons on the control panel while your hand is inside the printer. If the printer starts operating, it could cause an injury. Be careful not to touch the protruding parts to avoid injury.

  1. Remove the jammed paper.

  2. Remove the rear cover.

  3. Remove the jammed paper.

  4. Remove jammed paper from the rear cover.

  5. Insert the rear cover in the printer.

  6. Open the front cover.

  7. Lower the output switch lever.

  8. Remove the jammed paper.

    Important:

    Do not touch the parts inside the printer. Doing so may cause a malfunction.

  9. Raise the output switch lever.

  10. Close the front cover.

  11. Open the printer cover, and then use the knob to fasten it to the top.

  12. Remove the jammed paper.

    Important:

    Do not touch the white flat cable, translucent film, and ink tubes inside the printer. Doing so may cause a malfunction. If you touch the translucent film, make sure you clean it.

  13. Close the printer cover until it clicks.