You can copy a disc label or a square original such as a photo onto a disc label.
Various Prints > Disc label/Jewel case > Copy to Disc label
Before printing on the disc, see the disc handling precautions.
Do not insert the disc/ID card tray while the printer is operating. This may damage the printer.
Do not insert the disc/ID card tray until you are instructed to do so. Otherwise, an error occurs and the disc is ejected.
Place a disc on the disc/ID card tray with the printable side facing up. Press the center of the disc to securely set it on the disc/ID card tray. Otherwise, the disc may fall off the tray. Turn over the tray to check that the disc is firmly secured in the tray.
After printing is finished, make sure you remove the disc/ID card tray. If you do not remove the tray and turn the printer on or off, or run head cleaning, the disc/ID card tray will strike the print head and may cause the printer to malfunction.
You can set 114 to 120 mm as the outer diameter, and 18 to 46 mm as the inner diameter in 1 mm increments.
The outer diameter and the inner diameter you set are restored to their defaults after printing the disc label. You need to set these diameters every time you print.
To make a test print, select Test print on A4 paper, and then load A4 plain paper in the rear paper feeder. You can check the printout image before printing on a disc label.
You may feel slight friction when inserting the tray into the printer. This is normal and you should continue to insert it horizontally.
Select 
to view the scanned image. You can adjust the printing position on the preview screen.