You can select photos stored on a memory device to print onto a disc label.
Various Prints > Disc label/Jewel case > Print on Disc label
Before printing on the disc, see the disc handling precautions.
Do not insert the Disc/ID card tray while the printer is operating. This may damage the printer.
Start printing and insert the Disc/ID card tray when you are instructed to do so. Otherwise, an error occurs and the disc is ejected.
When printing on or copying the disc, instructions are displayed on the control panel informing you when to load the disc. Follow the on-screen instructions.
Place a disc on the Disc/ID card tray with the printable side facing up. Press the center of the disc to securely set it on the Disc/ID card tray. Otherwise, the disc may fall off the tray. Turn over the tray to check that the disc is firmly secured in the tray.
After printing is finished, make sure you remove the Disc/ID card tray. If you do not remove the tray and turn the printer on or off, or run head cleaning, the Disc/ID card tray will strike the print head and may cause the printer to malfunction.
When you change the outer and inner diameter, select 
at the upper-right of the screen, and then select Disc label Inner/Outer. Set the outer and inner diameter using - + buttons and then select OK. You can also set the diameter by selecting the value in the frame and using the on-screen keypad.
You can set 114 to 120 mm as the outer diameter, and 18 to 46 mm as the inner diameter in 1 mm increments.
The inner diameter and the outer diameter you set are restored to their defaults after printing the disc label. You can change the defaults in Settings > Printer Settings > Disc label Inner/Outer.
You may feel slight friction when inserting the tray into the printer. This is normal and you should continue to insert it horizontally.