A Message is Displayed on the LCD Screen

Printer Error

Turn on the printer again. See your documentation for more details.

Remove any paper or protective material in the printer. If the error message is still displayed, contact Epson support.

Paper out in XX.

Load paper in the displayed paper source, and if you load paper in the paper cassette, insert it all the way.

Paper Setup Auto Display is set to Off. Some features may not be available. For details, see your documentation.

If Paper Setup Auto Display is disabled, you cannot use AirPrint.

The combination of the IP address and the subnet mask is invalid. See your documentation for more details.

Enter the correct IP address or default gateway. Contact the person who setup the network for assistance.

To use cloud services, update the root certificate from the Epson Web Config utility.

Run Web Config, and then update the root certificate.

Check that the printer driver is installed on the computer and that the port settings for the printer are correct.

Make sure the printer port is selected correctly in Property > Port from the Printer menu as follows.

Select "USBXXX" for a USB connection, or "EpsonNet Print Port" for a network connection.

Recovery Mode

Update Firmware

The printer has started in recovery mode because the firmware update failed. Follow the steps below to try to update the firmware again.

1. Connect the computer and the printer with a USB cable. (During recovery mode, you cannot update the firmware over a network connection.)

2. Visit your local Epson website for further instructions.