Select the menus on the control panel as described below.
Settings > General Settings > Network Settings
Network Settings
Wi-Fi Setup
Set up or change wireless network settings. Choose the connection method from following and then follow the instructions on the control panel.
Wi-Fi (Recommended)
Set up or change wireless network settings. Choose the connection method from following and then follow the instructions on the control panel.
Wi-Fi Setup Wizard
Makes Wi-Fi settings by entering the SSID and password.
Push Button Setup (WPS)
Makes Wi-Fi settings by Push Button Setup (WPS).
Others
PIN Code Setup (WPS)
Makes Wi-Fi settings by PIN Code Setup (WPS).
Wi-Fi Auto Connect
Makes Wi-Fi settings by using the Wi-Fi information on the computer or smart device.
Disable Wi-Fi
Disables Wi-Fi. Infrastructure connections will be disconnected.
Wi-Fi Direct
Other Methods
iOS
Reads the QR code from your iPhone, iPad, or iPod touch to connect using Wi-Fi Direct.
Other OS Devices
Makes Wi-Fi Direct settings by entering the SSID and password.
(Menu)
Change Network Name
Changes the Wi-Fi Direct SSID (network name).
Change Password
Changes the password for the Wi-Fi Direct connection.
Disable Wi-Fi Direct
Disables the Wi-Fi Direct function.
Restore Default Settings
Restores the Wi-Fi Direct settings.
Wired LAN Setup
Set up or change a network connection that uses a LAN cable and router. When this is being used, Wi-Fi connections are disabled.
Network Status
Wired LAN/Wi-Fi Status
Displays the printer's network information.
Wi-Fi Direct Status
Displays the Wi-Fi Direct setting information.
Print Status Sheet
Prints a network status sheet.
The information for Ethernet, Wi-Fi, Wi-Fi Direct, and so on is printed on two or more pages.
Connection Check
Checks the current network connection and prints a report. If there are any problems with the connection, see the report to solve the problem.
Advanced
Device Name
Changes the device name to any name within 2 to 15 characters.
TCP/IP
Configures the IP settings, if the IP address is static.
For automatic configuration, use the IP address assigned by DHCP.
To set manually, switch to "Manual" and then enter the IP address you want to assign.
Proxy Server
Set this if you are using a proxy server in your network environment and want to set it for the printer as well.
IPv6 Address
Sets whether or not to enable IPv6 addressing.
Link Speed & Duplex
Select an appropriate Ethernet speed and duplex setting. If you select a setting other than Auto, make sure the setting corresponds to the settings on the hub you are using.
(Menu)