When the finisher is installed, the menu below is displayed on the printer's control panel.
Feature names and setting menu items may change depending on the firmware version.
Job Separation
Select On to output copies separated by jobs.
Align when Staple
Reduce paper misalignment to improve stapling performance. However, this may lower print speed.
Align when Non-staple
Reduce paper misalignment. However, this may lower print speed.
Align when Fold and Saddle Stitch
Reduce paper misalignment to fold or saddle stich each set of copies in the correct position. However, this may lower print speed.
This option is displayed only when the booklet finisher is installed.
These menus are displayed only when the staple finisher or the booklet finisher is installed.
Avoid Contact of Stacked Paper with the Moving Part
Lower the finisher tray to eject documents so that it does not come into contact with the ejected documents. However, this may lower print speed.
Change Maximum Stack Detection Point
Change the number of full sheets detected in the finisher tray from 4000 to 1500.
These menus are displayed only when the staple finisher-P2 is installed. When panel lock is enabled, only the administrator can make these settings.
Quiet Mode
If ejection operation sounds are too loud during paper ejection, set this mode to On. However, this may lower print speed.
Also, when printing density is high, shift sort is being performed, or stapling is being performed, the printer automatically aligns the paper and may not be able to reduce the noise level during paper ejection.
When this setting is enabled, the accuracy of the alignment of the ejected paper will be reduced.
Avoid Contact of Stacked Paper with the Moving Part
Lower the finisher tray to eject documents so that it does not come into contact with the ejected documents. However, this may lower print speed.
Change Maximum Stack Detection Point
Change the number of full sheets detected in the finisher tray from 4000 to 1500.
Paper Delivering Adjustment
Reduce paper misalignment when printing at a high print density using the finisher.
Paper Ejection Fan
Reduce paper misalignment or the causes of paper jams. If paper cannot be ejected and paper jams continue to occur, you may be able to solve the problem by enabling this setting. Please contact Epson support or an authorized Epson service provider when you change this setting.