Network Settings

Set up or change wireless network settings. Choose the connection method from following and then follow the instructions on the control panel.

Makes Wi-Fi settings by entering the SSID and password.

Makes Wi-Fi settings by Push Button Setup (WPS).

• PIN Code Setup (WPS)

  Makes Wi-Fi settings by PIN Code Setup (WPS).

• Wi-Fi Auto Connect

  Makes Wi-Fi settings by using the Wi-Fi information on the computer or smart device.

• Disable Wi-Fi

  Disables Wi-Fi. Infrastructure connections will be disconnected.

• iOS

  Reads the QR code from your iPhone, iPad, or iPod touch to connect using Wi-Fi Direct.

• Other OS Devices

  Makes Wi-Fi Direct settings by entering the SSID and password.

• Change Network Name

  Changes the Wi-Fi Direct SSID (network name).

• Change Password

  Changes the password for the Wi-Fi Direct connection.

• Change Frequency Range

  Select the frequency band for Wi-Fi Direct connection. Changing the frequency disconnects the connected device.

  The availability of these channels and use of the product outdoors over these channels varies by location.

  http://support.epson.net/wifi5ghz/

• Disable Wi-Fi Direct

  Disables the Wi-Fi Direct function.

• Restore Default Settings

  Restores the Wi-Fi Direct settings.

Set up or change a network connection that uses a LAN cable and router. When this is being used, Wi-Fi connections are disabled.

Displays the printer's network information.

Displays the Wi-Fi Direct setting information.

Prints a network status sheet.

The information for Ethernet, Wi-Fi, Wi-Fi Direct, and so on is printed on two or more pages.

Checks the current network connection and prints a report. If there are any problems with the connection, see the report to solve the problem.

Changes the device name to any name within 2 to 53 characters.

Configures the IP settings, if the IP address is static.

For automatic configuration, use the IP address assigned by DHCP.

To set manually, switch to "Manual" and then enter the IP address you want to assign.

Set this if you are using a proxy server in your network environment and want to set it for the printer as well.

Sets whether or not to enable IPv6 addressing.

Select an appropriate Ethernet speed and duplex setting. If you select a setting other than Auto, make sure the setting corresponds to the settings on the hub you are using.

Enables or disables redirecting from HTTP to HTTPS.

Disables the IPsec/IP filtering setting.

Disables the IEEE802.1X setting.

Select whether to enable or disable the iBeacon transmission function. When enabled, you can search for the printer from iBeacon-enabled devices.