Setting the Paper Source

1. Enter the printer's IP address into a browser to access Web Config.

   Enter the printer's IP address from a computer that is connected to the same network as the printer.

   You can check the IP address of the printer from the following menu.

   Settings > General Settings > Network Settings > Network Status > Wired LAN/Wi-Fi Status

2. Enter the administrator password to log in as an administrator.

3. Select in the following order.

   Print tab > Paper Source Settings

4. Set each item.

   The displayed items may vary by the situation.

   • Paper source name
     Display the target paper source name, such as Paper Tray, Cassette 1.
   • Paper Size
     Select the paper size you want to set from the pull-down menu.
   • Unit
     Select the unit of the user-defined size. You can select it when User defined is selected on Paper Size.
   • Width
     Set the horizontal length of the user-defined size.
     The range you can enter here depends on the paper source, which is indicated on the side of Width.
     When you select mm in Unit, you can enter up to one decimal place.
     When you select inch in Unit, you can enter up to two decimal places.
   • Height
     Set the vertical length of the user-defined size.
     The range you can enter here depends on the paper source, which is indicated on the side of Height.
     When you select mm in Unit, you can enter up to one decimal place.
     When you select inch in Unit, you can enter up to two decimal places.
   • Paper Type
     Select the paper type you want to set from the pull-down menu.

5. Check the settings, and then click OK.