Assigning the IP Address (When Using an Additional Network)

1. Turn on the printer.

2. Select Settings on the home screen on the printer's control panel.

3. Select General Settings > Network Settings.

4. Select Standard or Additional for the network that you want to set up.

5. Select Advanced > TCP/IP.

   Note:

   When you select Advanced, you need to enter the administrator password for the additional network.

6. Select Manual for Obtain IP Address.

   When you set the IP address automatically by using the DHCP function of router, select Auto. In that case, the IP Address, Subnet Mask, and Default Gateway on step 7 to 8 are also set automatically, so go to step 9.

7. Enter the IP address.

   When entering an IP Address, enter zeroes (0) to make three digits as shown in the following example.

   Example:

   • If the IP address is 192.0.2.111, enter 192.000.002.111.
   • If the IP address is 192.0.12.10, enter 192.000.012.010

   Confirm the value reflected on the previous screen. After the IP address is entered, the zeroes you entered to make three digiits are omitted.

8. Set up the Subnet Mask and Default Gateway.

   Confirm the value reflected on the previous screen.

   Important:

   If the combination of the IP Address, Subnet Mask and Default Gateway is incorrect, Start Setup is inactive and cannot proceed with the settings. Confirm that there is no error in the entry.

9. Enter the IP address for the primary DNS server.

   Confirm the value reflected on the previous screen.

   Note:

   When you select Auto for the IP address assignment settings, you can select the DNS server settings from Manual or Auto. If you cannot obtain the DNS server address automatically, select Manual and enter the DNS server address. Then, enter the secondary DNS server address directly. If you select Auto, go to step 11.

10. Enter the IP address for the secondary DNS server.

    Confirm the value reflected on the previous screen.

11. Tap Start Setup.