Before Using the Printer
Part Names
Setup
Basic Operations
Cleaning
Troubleshooting
Appendix
Top > Setup > Checking/Changing the Installation Direction
Checking/Changing the Installation Direction
Paper eject position are selectable from top and front.
Place the printer on a flat surface.
Top eject position
Front eject position
CAUTION:-
Take measures to prevent the printer from moving due to vibrations when using the cash drawer.
-
Do not place the printer in locations subject to high dust levels.
-
Do not give a high impact on the printer during operation. Doing so may cause the print failure.
-
Be careful not to place cords or foreign substances under the printer.
Note:You can install the printer as a wall hanging printer if you use the optional Wall Hanging Bracket Set (OT-WH30). Refer to the installation manual of the Wall Hanging Bracket Set for details.
Changing to the front eject position
You can change the eject position by replacing the rear cover and the bottom cover. At the time of purchase, paper is ejected from the top position. When changing to the front eject position, follow the steps below to replace the covers.
-
Remove the bottom cover and the rear cover. See For the top eject position for more details on the removal procedure.
-
Attach the rear cover and the bottom cover. See For the front eject position for more details on the installation procedure.
Before Using the Printer
Part Names
Setup
Basic Operations
Cleaning
Troubleshooting
Appendix
Top > Setup > Checking/Changing the Installation Direction
Checking/Changing the Installation Direction
Paper eject position are selectable from top and front.
Place the printer on a flat surface.
Top eject position
Front eject position
CAUTION:-
Take measures to prevent the printer from moving due to vibrations when using the cash drawer.
-
Do not place the printer in locations subject to high dust levels.
-
Do not give a high impact on the printer during operation. Doing so may cause the print failure.
-
Be careful not to place cords or foreign substances under the printer.
Note:You can install the printer as a wall hanging printer if you use the optional Wall Hanging Bracket Set (OT-WH30). Refer to the installation manual of the Wall Hanging Bracket Set for details.
Changing to the front eject position
You can change the eject position by replacing the rear cover and the bottom cover. At the time of purchase, paper is ejected from the top position. When changing to the front eject position, follow the steps below to replace the covers.
-
Remove the bottom cover and the rear cover. See For the top eject position for more details on the removal procedure.
-
Attach the rear cover and the bottom cover. See For the front eject position for more details on the installation procedure.