Confirm the following:
The default gateway address is correct if you set the printer’s TCP/IP Setup setting to Manual.
The device that is set as the default gateway is turned on.
Set the correct default gateway address. You can check the default gateway address from the Network Status section on the network connection report.
If your printer and network devices still do not connect after confirming the above, try the following.
Turn off the wireless router. Wait for about 10 seconds, and then turn it on.
Configure network settings from a computer on the same network as the printer by downloading and running the software from the following website.
https://support.epson.com (U.S. and Canada)
https://epson.sn > Setup (Other regions)