Checking Error Messages on the Control Panel

Feeding stopped to protect originals. Open the scanner cover and remove them.

Remove the original from the ADF and check the condition of the original.

Removing Jammed Originals from the Scanner

The original jammed. Open the scanner cover to remove the original.

Remove the original from the ADF.

Removing Jammed Originals from the Scanner

Check the following if a computer is not found. - Connection between the scanner and the computer (USB or network) - Installation of the necessary software - Power supply to the computer - Firewall and security software settings - Search again See your documentation for more details.

• Make sure the scanner is connected to your computer properly.

• Install Epson Scan 2 and Document Capture Pro (or Document Capture) on your computer.

• Install the latest version of the application.

• Make sure the power cord is securely connected to the scanner and an electrical outlet.

  Check that the electrical outlet is working. Plug another device into the electrical outlet and check that you can turn the power on.

• Check the firewall settings for Epson software.

• Set the same group for the scanner and the computer.

• Search for the computer again.

Inside the scanner may have some stains. Please clean the scanner.

See the following section to clean inside the scanner (ADF).

Cleaning the ADF

When cleaning is complete, reload the original in the ADF.

If the problem continues to occur after you have performed cleaning, contact your local dealer. In the U.S., Canada, and Latin America, contact Epson Support.

The original may be smeared or inside the scanner may have some stains. Remove smears on the original, and then clean inside the scanner.

The combination of the IP address and the subnet mask is invalid. See your documentation for more details.

Enter the correct IP address or default gateway. Contact the person who setup the network for assistance.

Recovery Mode

The scanner has started in recovery mode because the firmware update failed. Follow the steps below to try to update the firmware again.

1. Connect the computer and the scanner with a USB cable. (During recovery mode, you cannot update the firmware over a network connection.)

2. Visit your local Epson website for further instructions.