Printing original text repeatedly on a ribbon

Prints the same text repeatedly within the specified label length.

Note To use this function, use the dedicated ribbon cartridge. Other cartridges can also be used for this function. To cut the ribbon after printing is complete, remove the tape cartridge from the printer and use commercially available scissors to cut the ribbon, leaving about 3 mm length of ribbon protruding from the cartridge.

1. When finished entering text, press + .

2. Select "Continuous" with the cursor keys, and press .

3. Select "Tape Length" with the cursor keys, and press .

You can also specify the length using the number buttons.

Setting range: 5.0 to 99 cm (2.0 to 39.5″)

4. Select "Interval" with the cursor keys, and press .

You can also specify the length using the number buttons.

Setting range: 1.0 to 99 cm (0.40 to 39.5″)

5. Check the number of times the text will be repeated and press .

Printing is started.

The number of repetitions of a text is automatically determined by the length of the tape, the length of the text, the interval between text, etc.

Printing multiple different texts sequentially on a ribbon

1. When finished entering text, press .

2. Press + .

3. Select "Set Length" with the cursor keys, and press .

4. Select "Length" with the cursor keys, and press . The ribbon is fed by the specified length.

You can also specify the length using the number buttons.

Setting range: 2.0 to 99 cm (0.90 to 39.5″)

Enter another text, and repeat step 1 to 4.