Network Service and Software Information
Application for Scanning Documents and Images (Epson Scan 2)
Application for Configuring Scanning Operations from the Control Panel (Epson Event Manager)
Application for Configuring Fax Operations and Sending Faxes (FAX Utility)
Application for Quick and Fun Printing from a Computer (Epson Photo+)
Application for Easily Operating the Printer from a Smart device (Epson Smart Panel)
Application for Scanning and Transferring Images (Easy Photo Scan)
Application for Updating Software and Firmware (Epson Software Updater)
Application for Setting up the Device on a Network (EpsonNet Config)
Colored Banding Appears at Intervals of Approximately 3.3 cm
The Position, Size, or Margins of the Printout Are Incorrect
Uneven Colors, Smears, Dots, or Straight Lines Appear in the Copied Image
An Image of the Reverse Side of the Original Appears in the Copied Image
The Text or Image Copied from the ADF is Squeezed or Stretched
Do not block or cover the vents and openings in the printer.
Use only the type of power source indicated on the printer's label.
Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and off.
Avoid electrical outlets controlled by wall switches or automatic timers.
Keep the entire computer system away from potential sources of electromagnetic interference, such as loudspeakers or the base units of cordless telephones.
The power-supply cords should be placed to avoid abrasions, cuts, fraying, crimping, and kinking. Do not place objects on top of the power-supply cords and do not allow the power-supply cords to be stepped on or run over. Be particularly careful to keep all the power-supply cords straight at the ends and the points where they enter and leave the transformer.
If you use an extension cord with the printer, make sure that the total ampere rating of the devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure that the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's ampere rating.
If you plan to use the printer in Germany, the building installation must be protected by a 10 or 16 amp circuit breaker to provide adequate short-circuit protection and over-current protection for the printer.
When connecting the printer to a computer or other device with a cable, ensure the correct orientation of the connectors. Each connector has only one correct orientation. Inserting a connector in the wrong orientation may damage both devices connected by the cable.
Place the printer on a flat, stable surface that extends beyond the base of the printer in all directions. The printer will not operate properly if it is tilted at an angle.
When storing or transporting the printer, avoid tilting it, placing it vertically, or turning it upside down; otherwise ink may leak.
Allow space above the printer so that you can fully raise the document cover.
Leave enough space in front of the printer for the paper to be fully ejected.
Avoid places subject to rapid changes in temperature and humidity. Also, keep the printer away from direct sunlight, strong light, or heat sources.
Do not insert objects through the slots in the printer.
Do not put your hand inside the printer during printing.
Do not touch the white flat cable inside the printer.
Do not use aerosol products that contain flammable gases inside or around the printer. Doing so may cause fire.
Do not move the print head by hand; otherwise, you may damage the printer.
Be careful not to trap your fingers when closing the scanner unit.
Do not press too hard on the scanner glass when placing the originals.
Always turn the printer off using the button. Do not unplug the printer or turn off the power at the outlet until the light stops flashing.
Before transporting the printer, make sure that the print head is in the home (far right) position and the ink cartridges are in place.
If you are not going to use the printer for a long period, be sure to unplug the power cord from the electrical outlet.