About cable slot cover

When you pass cables through the right, left, or bottom of the printer, you can reattach the cable slot cover to hide the slot in the rear center.

To reattach the cover, hook the tab of the cover onto the rear cover, and then push the other side in.

A: Tab

B: Rear cover

Passing Cables through the Rear Center

Remove the cable slot cover, and then pass cables through the slot.

Passing Cables through the Left or Right

With your fingers, fold the tab on the side you want to pass cables and remove it to make a slot.

If the slot is jagged, smooth it out with nippers or a file to prevent the cables from being damaged.

Once the tabs are removed, they cannot be put back on. Make sure to decide how to route the cables before removing the tab.

Passing Cables through the Bottom

If the desk or table on which the printer is to be installed has a hole through which cables can pass, it is best to pass the cables through the slot in the bottom of the printer.

A: Rear cover

B: Slot in the bottom of the printer

C: Bottom cover