Inserting Tape Cartridges

You can use tapes with widths ranging from approximately 4 mm to 24 mm*.

Use appropriate tape cartridge labeled PX or LK that matches the symbol indicated on the printer.

*Depending on the model, 4 mm wide tape may not be supported.

Note Make sure the power is off before you install a tape cartridge.

1. Remove any slack from the ribbon using a pencil or pen.

This prevents ribbon breakage during printing.



2. Open the tape cover.



3. Insert the cartridge as shown and press it down firmly until it snaps into place.

Make sure the end of the tape slides into the ejection slot.



4. Close the cover.