Network Service and Software Information
Application for Scanning Documents and Images (Epson Scan 2)
Application for Configuring Scanning Operations from the Control Panel (Epson Event Manager)
Application for Configuring Fax Operations and Sending Faxes (FAX Utility)
Application for Quick and Fun Printing from a Computer (Epson Photo+)
Application for Easily Operating the Printer from a Smart device (Epson Smart Panel)
Application for Updating Software and Firmware (Epson Software Updater)
Application for Setting up the Device on a Network (EpsonNet Config)
Colored Banding Appears at Intervals of Approximately 2.5 cm
The Position, Size, or Margins of the Printout Are Incorrect
Uneven Colors, Smears, Dots, or Straight Lines Appear in the Copied Image
An Image of the Reverse Side of the Original Appears in the Copied Image
The Text or Image Copied from the ADF is Squeezed or Stretched
There are two methods available to disable a Wi-Fi Direct (Simple AP) connection; you can disable all connections by using the printer's control panel, or disable each connection from the computer or the smart device. This section explains how to disable all connections.
When Wi-Fi Direct (Simple AP) connection disabled, all computers and smart devices connected to the printer in Wi-Fi Direct (Simple AP) connection are disconnected.
If you want to disconnect a specific device, disconnect from the device instead of the printer. Use one of the following methods to disconnect the Wi-Fi Direct (Simple AP) connection from the device.
Disconnect the Wi-Fi connection to the printer's network name (SSID).
Connect to another network name (SSID).
Select Wi-Fi Setup on the home screen.
To select an item, use the buttons, and then press the OK button.
Select Wi-Fi Direct.
Press the OK button to proceed.
Press the OK button to proceed.
Press the button to display the setting screen.
Select Disable Wi-Fi Direct.
Check the message, and then press the OK button.