Network Service and Software Information
Application for Scanning Documents and Images (Epson Scan 2)
Application for Configuring Scanning Operations from the Control Panel (Epson Event Manager)
Application for Configuring Fax Operations and Sending Faxes (FAX Utility)
Application for Quick and Fun Printing from a Computer (Epson Photo+)
Application for Easily Operating the Printer from a Smart device (Epson Smart Panel)
Application for Updating Software and Firmware (Epson Software Updater)
Application for Setting up the Device on a Network (EpsonNet Config)
Colored Banding Appears at Intervals of Approximately 2.5 cm
The Position, Size, or Margins of the Printout Are Incorrect
Uneven Colors, Smears, Dots, or Straight Lines Appear in the Copied Image
An Image of the Reverse Side of the Original Appears in the Copied Image
The Text or Image Copied from the ADF is Squeezed or Stretched
Message |
Solution |
---|---|
The Wi-Fi environment needs to be improved. Turn the wireless router off and then turn it on. If the connection does not improve, see the documentation for the wireless router. |
After moving the printer closer to the wireless router and removing any obstacles between them, turn off the wireless router. Wait for about 10 seconds, and then turn it on. If it still does not connect, see the documentation supplied with the wireless router. |
*No more devices can be connected. Disconnect one of the connected devices if you want to add another one. |
Computer and smart devices that can be connected simultaneously are connected in full in the Wi-Fi Direct (Simple AP) connection. To add another computer or smart device, disconnect one of the connected devices or connect it to the other network first. You can confirm the number of wireless devices which can be connected simultaneously and the number of connected devices by checking the network status sheet or the printer’s control panel. |
The same SSID as Wi-Fi Direct exists in the environment. Change the Wi-Fi Direct SSID if you cannot connect a smart device to the printer. |
On the printer’s control panel, go to Wi-Fi Direct Setup screen and select the menu to change the setting. You can change the network name following after DIRECT-XX-. Enter within 32 characters. |