E-12
Check the following.
-
Other devices on the network are turned on.
-
The network addresses (IP address, subnet mask, and default gateway) are correct if you are entering them manually.
-
The network addresses for other devices (subnet mask and default gateway) are the same.
-
The IP address does not conflict with other devices.
If still does not connect your printer and network devices after confirming the above, try the following.
-
Turn off the wireless router. Wait for about 10 seconds, and then turn it on.
-
Make network settings again using the installer. You can run it from the following website.
http://epson.sn > Setup
-
You can register several passwords on a wireless router that uses WEP security type. If several passwords are registered, check if the first registered password is set on the printer.
