Making Wi-Fi Direct (Simple AP) Connection Settings
This method allows you to connect the printer directly to devices without a wireless router. The printer acts as a wireless router.
-
While holding down the
button, press the 
button until the 
light and the 
light flash alternately.
Wait until the process ends.
When a connection is established, the
light turns on.
Note:If you enable Wi-Fi Direct once, it remains enabled unless you restore the default network settings.
-
Load papers.
-
Hold down the
button on the printer for at least 5 seconds.
The network status sheet is printed. You can check the SSID and Password for Wi-Fi Direct (Simple AP) on this sheet.
Note:If you release the
button within 5 seconds, a network connection report is printed. Note that the SSID and Password for Wi-Fi Direct (Simple AP) are not printed on this report.
-
On the computer's network connection screen or the smart device's Wi-Fi screen, select the same SSID shown on the network status sheet to connect.
-
Enter the password printed on the network status sheet into the computer or smart device.
You can confirm the status of Wi-Fi Direct on the network status sheet.
When you connect from a smart device using Wi-Fi Direct connection (for Android)
When you are using an Android device and connect to the printer using Wi-Fi Direct, the light and light flash simultaneously on the printer.
Press the button to allow the connection request.
Press the 
button if you want to reject the connection request.
See Tips on the following website for more details.
http://epson.sn > Support
