Replacing the Roller Assembly Kit

The roller assembly kit (the pickup roller and the separation roller) needs to be replaced when the number of scans exceeds the life cycle of the rollers. When a replacement message is displayed on the control panel or your computer screen, follow the steps below to replace it.

A: pickup roller, B: separation roller

1. Press the button to turn off the scanner.

2. Unplug the AC adapter from the scanner.

3. Pull the lever and open the scanner cover.

   

4. Open the cover of the pickup roller, and then slide and remove it.

   

5. Pull down the fixture of the roller axis, and then slide and remove the installed pickup rollers.

   
   Important:

   Do not pull out the pickup roller forcibly. This could damage the inside of the scanner.

6. While holding down the fixture, slide the new pickup roller to the left and insert it into the hole in the scanner. Press the fixture to secure it.

   

7. Put the edge of the cover of the pickup roller into the groove and slide it. Close the cover firmly.

   
   Important:

   • Make sure the pick up cover is closed correctly.

   • Make sure the pickup rollers are installed correctly if the cover is hard to close.

   • Do not install the cover while it is raised.

     

8. Push the hooks on both ends of the separation roller cover to open the cover.

   

9. Lift the left side of the separation roller, and then slide and remove the installed separation rollers.

   

10. Insert the new separation roller axis into the hole on the right side, and then lower the roller.

    

11. Close the separation roller cover.

    Important:

    If the cover is hard to close, make sure the separation rollers are installed correctly.

12. Close the scanner cover.

13. Plug in the AC adapter, and then turn on the scanner.

14. Reset the scan number on the control panel.