Running Web Config on a Web Browser

1. Check the scanner's IP address.

   Select Settings > Network Settings > Network Status on the scanner's control panel. Then select the active connection method (Wired LAN/Wi-Fi Status or Wi-Fi Direct Status) to confirm the scanner's IP address.

2. Launch a Web browser from a computer or a smart device, and then enter the scanner's IP address.

   Format:

   IPv4: http://scanner’s IP address/

   IPv6: http://[scanner’s IP address]/

   Example:

   IPv4: http://192.168.100.201/

   IPv6: http://[2001:db8::1000:1]/

   Note:

   Since the scanner uses a self-signed certificate when accessing HTTPS, a warning is displayed on the browser when you start Web Config; this does not indicate a problem and can be safely ignored.

3. Login as an administrator to change the scanner settings.

   Click Log in at the top-right of the screen. Enter the User Name and Current password, and then click OK.

   Note:

   • The following provides the initial values for the Web Config administrator information.

     ·User name: none (blank)

     ·Password: Depends on the label attached to the back of the product.

     If there is a "PASSWORD" label attached to the back, enter the 8-digit number shown on the label.

     If there is no "PASSWORD" label attached, enter the serial number on the label attached to the back of the product for the initial administrator password.

   • If Log out is displayed at the top-right of the screen, you are already logged in as an administrator.

   • You will be logged out automatically after approximately 20 minutes of inactivity.