Scanning in Automatic Feeding Mode

1. Start Epson Scan 2.

   Note:

   When you are using Document Capture Pro, you can open the Epson Scan 2 window by pressing the Detailed Settings button on the scan settings screen.

2. Select Automatic Feeding Mode on the Main Settings tab.

   

3. Make other settings for scanning in the Epson Scan 2 main window.

4. Click Scan.

   Note:

   When you are using Document Capture Pro, click Save to save the scan settings. When you start scanning, Automatic Feeding Mode starts.

   Automatic Feeding Mode starts.

   The Automatic Feeding Mode window is displayed on your computer and the scanner.

   

5. Adjust the edge guides, and then place the original in the ADF.

   Scanning starts automatically.

6. After scanning stops, place the next original in the ADF.

   Repeat this procedure until you have scanned all originals.

   Note:

   You can set Scanner Settings on the scanner's control panel.

   · Slow: Slows down the scanning speed. Use this to scan originals that are likely to jam, for example thin paper.

   · Double Feed Stop Timing: Set the operation when any double feed is detect.

   · DFDS Function: Skips double feed detection once and continues scanning. Use this to scan originals that are detected as double feeds, for example plastic cards or envelopes.

   · Paper Protection: Reduces damage to the originals by stopping scanning immediately when a feeding error occurs.

   · Glass Dirt Detection: Detects dirt on the glass surface inside the scanner.

7. After you have scanned all originals, close Automatic Feeding Mode.

   Select Done on the scanner's control panel or press Finish on the Automatic Feeding Mode screen displayed on your computer.

   Note:

   You can make timeout settings to exit Automatic Feeding Mode.

   Select Settings on the Document Source list to open the Document Source Settings screen. Set the timeout time on the screen displayed.

   The scanned image is saved to the folder you specified.